SWR Fitting

Fittings decide whether a drainage system stays silent or starts gurgling. Every direction change, vent connection and access point in an SWR line runs through a fitting, and a rough or ill-fitting one is where blockages start and odours escape.

WorldFlow's SWR fittings range — bends, tees, traps, cowls and access doors — is manufactured to IS 13592, in both ring-fit (EPDM-sealed, serviceable) and solvent-pasting (permanent, economical) types, so the right joint method can be used at each point in the system.

Swept bends instead of sharp turns keep solids moving without catching, properly sized traps hold their water seal, and vent cowls keep air moving through the stack the way the system was designed to breathe.

The full range is built to work as one matched system with WorldFlow's SWR pipes, for residential soil and waste stacks, rainwater lines, and commercial drainage installations. Enquire with your layout and we'll list out the fittings needed.